46
DHOLLANDIA
15
MOUNTING OF THE SIDE STEPS & DOCK BUMPERS
1.
There are 2 possible set-ups [see also drawings in appendix]:
I.
Side steps directly bolted to floor extension plate by means of 2 bolts M16 [1 in Figure 15.1], to obtain 2440mm overall
width (for 2130mm platform width).
II.
Side steps with intermediate mounting blocks [2 in Figure 15.1], bolted together in 2 subsequent steps by means of 2+2
bolts M16 [1+2 in Figure 15.1] to obtain 2590mm overall width (for 2310mm platform width).
2.
Bolt the side steps to the floor extension as shown. If a 2590mm extension kit is specified, install the extension kit [far right in
Figure 15.1] before mounting the side steps.
3.
Maintain a 90° angle between the steps and the extension plate. [Figure 15.2]
4.
Fasten all bolts and locking nuts to the required torque settings.
Figure 15.1
Figure 15.2
5.
Weld the support channels to the rear sill and underside of the I-beam cross members [Figure 15.3]. Weld to as many I-beam or
cross members as possible, to distribute the forces of dock impact as much as possible.
Per side
❶
2x M16x2 (8.8) 195 Nm 143 lbs-ft
❷
2x M16x2 (8.8) 195 Nm 143 lbs-ft
❶
❶
❷
Summary of Contents for DH-RM.25
Page 12: ...11 DHOLLANDIA Figure 6 2...
Page 34: ...33 DHOLLANDIA Figure 11 5 Figure 11 4...
Page 46: ...45 DHOLLANDIA Figure 14 1 Figure 14 2...
Page 52: ...51 DHOLLANDIA...