Dhollandia DH-RM.25, Installation Manual, Page: 19 / 79

18
DHOLLANDIA
NOTICE
Where chassis beams, longs sills, the rear sill and other steel chassis or body components have been cut, grinded, drilled, etc…,
the installer should apply adequate anti-corrosive coating to protect the vehicle and body against corrosion. Check, and make
sure you comply with the instructions of the OEM vehicle manufacturer.
8 MOUNTING OF THE EXTENSION PLATE

The extension plate is supplied in galvanized finish and is intended to be bolted to the rear sill of the body. It is allowed to weld
the extension to the rear sill, in addition to bolting, if desired.

There are 2 models [see drawing in appendix]:
1. Floor extension 2430mm wide (incl. side steps) for 2145mm platform width;
2. Floor extension 2590mm wide (incl. side steps) for 2300mm platform width

Measure and mark the centre line of the body and sill.

Measure and mark the centre line of the extension plate.

Before drilling, verify the actual holes in the extension plate supplied with the drawing on right [Figure 8.1].

Measure, mark and drill the 13 holes dia. 14.3mm required for mounting the extension, then coat the holes to protect against
corrosion.

Position the floor extension up to the rear sill using a fork lift or hoists.
Figure 8.1
Dimensions table
mm
A 1180
B 864
C 736
D 610
E 356
F 178
G 83
H 35
A
B
C
D
E
F G
H