40
DHOLLANDIA
4
ADJUSTMENT INSTRUCTIONS
The wheelchair lift can be adjusted in numerous ways, this way it can comply to a wide array of different bus types.
In case of any doubt regarding these adjustments, please contact your national DHOLLANDIA distributor for further advice prior
to continuing.
A wheelchair lift is normally set-up in the factory to the desired dimensions as described in the order forms. Please check if the
original set-up complies to your installation case, prior to making any of the adjustments mentioned below.
If the desired result can’t be reached by using the adjustments in section 4.2 and 4.3, please contact your national DHOLLANDIA
distributor for further advice before altering these factory settings.
When adjustments have been made, re-check the PDI checklist.
4.1
FACTORY SETTINGS
The wheelchair lift will be set up in the factory based on the drawing received during the order phase. These settings should
not be adjusted during the installation or operation of the wheelchair lift.
The components shown on the pictures below will be adjusted to alter the angle of the platform and the way the lift will return
to its storage position. The set-up of these components is crucial to assure a good working lift and should only be done in the
factory or service station by trained individuals when it is strictly necessary.
