RPM4™ OPERATION AND MAINTENANCE MANUAL
© 2004-2007 DH Instruments, a Fluke Company
Page 106
UDU
Purpose
Read or set the user defined pressure unit.
Command
Query
“UDU
label, ucoef
”
“UDU?”
Classic “UDU=
label, ucoef
”
“UDU”
label:
User unit label (4 alphanumeric char maximum). It cannot be an already
supported unit label.
Ucoef
:
“User unit conversion coefficient (units/Pa).
Default
“UDU USER,1.0”
Remarks
The user defined unit must be set up with the program message prior to remote or local
selection.
Example
(enhanced)
Cmd Sent:
Query reply:
“UDU MYUN, .001”
“MYUN, 0.001000”
(No reply if GPIB-488)
Example
(enhanced)
Cmd Sent:
Query reply:
“UDU? MYUN, .001”
“MYUN, 0.001000”
Example
(enhanced)
Sent:
Reply:
“UDU=MYUN, .001”
“MYUN, 0.001000”
Errors
See Also
3.5.6, 3.3.2
UL
n
Purpose
Read or set an upper limit for the specified or active Q-RPT.
Command
Query
“Ul
n
limit
”
“Ul
n
?”
Classic “Ul
n
=
limit
”
“UL
n
”
Optional Suffix
“n”
The active Q-RPT is assumed if no suffix is given.
‘1’ Specify the Hi Q-RPT if the Hi and Lo Q-RPTs are NOT OFF and the HL
Q-RPT is not active.
Specify the HL Q-RPT if the Hi and Lo Q-RPTs are OFF
‘2’ Specify the Lo Q-RPT if the HL Q-RPT is not active and measurement
mode is not differential.
‘3’ Specify the HL Q-RPT if the HL Q-RPT is active.
Arguments
“limit":
The upper limit pressure in the specified Q-RPT’s current pressure unit and
measurement mode. If the unit is meters, this value is be interpreted in kPa. If
the unit is feet, this value is be interpreted in psi.
Remarks
The RPM4 has an upper limit for each range and for each measurement mode (gauge, absolute, and
differential). If the pressure does exceed the upper limit, the pressure display flashes. This
feature should always be used to prevent accidental over pressure of a device under test.
Example
(enhanced)
Cmd sent:
Query reply:
“UL 1000”
“1000.00 kPa a” (No reply if GPIB-488)
Example
(enhanced)
Cmd sent:
Query reply:
“UL? 1000”
“1000.00 kPa a”
Example
(classic)
Sent:
Reply:
“UL=1000”
“1000.00 kPa a”
Errors
ERR# 6:
The “
limit
” argument is out of range.
See Also
“LL”
3.4.4
