molbloc, molbloc-S, molbox, molstic and molstic-s are trademarks, registered and otherwise, of
DH Instruments, Inc.
VCR is a registered trademark of the Swagelok Company.
Document 560070
040907
DH Instruments, Inc.
4765 East Beautiful Lane
Phoenix AZ 85044-5318
USA
Tel 602.431.9100
Fax 602.431.9559
www.dhinstruments.com
INSTALLATION OF CRADLES ONTO MOLSTIC-S PLATFORM
With the molstic-S resting on its side, position the upstream cradle for the 32 mm molbloc-L into the desired
location, either 1, 2, or 3.
Place a lock washer and then a flat washer onto the socket head cap screw.
Thread the screw into the upstream cradle from the bottom side of the molstic platform and leave loose enough
to allow for later adjustment.
Thread another screw with lock washer and flat washer into the other side of the upstream cradle.
Position the downstream cradle for the 32 mm molbloc-L into the desired location, either 4, 5, or 6.
Thread screws into this cradle.
Repeat these step with any other cradles that might need to be installed.
For best alignment results, plumb the appropriate molbloc element into each branch of the molstic prior to final
tightening of the socket head cap screws.
The following parts are included in the shipment:
DESCRIPTION
QTY
PART NO.
Cradle, Low/Mid
2
122440
SHC screw, M4 x 10
4
101015-Z
Split lock washer, M4
4
102668-Z
Flat washer, M4
4
100918-Z
Instruction Sheet
1
560070
