Avenger96
–
Getting Started
R03
DOC_Getting-Started-588-200.docx
Page 19 / 19
1.3.8
SSH server
The pre-installed Linux automatically starts SSH server on all interfaces. One can connect to the board by exe-
cuting the following command on the PC (which has access to the same network as the Avenger96):
# ssh root@[IP address of board]
1.3.9
Debug UART
U-Boot and Linux boot logs as well as a standard Linux console is accessible on the debug UART connected to
pin 11 and 13 on the low-speed expansion connector (UART1 - see above). One can log into the Linux tty console
with the help of a USB-serial converter like this:
https://www.96boards.org/product/uartserial/
Any other USB-serial converter can be attached to the UART1 pins but care must be taken that signal levels are
1.8V CMOS.
1.3.10
Show Image Information
Show image infromation:
# cat /etc/issue