Troubleshooting
The Imprinted Location Isn't Where Desired.
Is the material loaded at the
correct location?
Verify that the base unit is installed correctly. Also verify that the
laser pointer points to the center of the material to be imprinted
and adjust the position as necessary.
Striking is performed, but
nothing is imprinted.
Does the material meet the requirements for imprinting with
this machine?
Prepare and use imprintable material.
P. 42 "Preparing the Material"
If you’re not using a head
cap, does the head position
match the surface height of
the material?
If you’re not using a head cap, check if the head position matches
the surface height of the material. Imprinting cannot be per-
formed if the head position does not match the height position
of the material. Adjust the head position and then tighten the
knob firmly.
Is the origin point of the ma-
chine displaced?
If the origin point is displaced, text and images will not be im-
printed at the desired position. Using MPX-95 Head Manager,
adjust the origin point.
P. 111 "Adjusting the Origin Location"
Is the marking pin bent or
broken?
If nothing is imprinted and changing the location where the
material is loaded, the parameters for the material, or the height
of the head unit does not correct the problem, then the marking
pin may be bent or broken. Try changing to an unused marking
pin and carry out test imprinting. If you can imprint with the new
marking pin, it means the marking pin you were using is bent or
broken. Continue using the new marking pin.
Not bent or
broken
Bent or
broken
Bent or
broken
4
Trouble
-
shooting
120
