14. 3. 2016
GPS/GPRS/GSM Module V3.0 (SKU:TEL0051) Robot Wiki
http://www.dfrobot.com/wiki/index.php/GPS/GPRS/GSM_Module_V3.0_(SKU:TEL0051)
1/20
GPS/GPRS/GSM Module V3.0 (SKU:TEL0051)
GPS/GPRS/GSM Module V3.0
(SKU:TEL0051)
From Robot Wiki
Contents
1 Introduction
2 Specification
3 Pin Out
4 Tutorial
4.1 How to drive the
GSM Mode via USB port
4.1.1 GSM mode &
GPS mode
Selection
4.1.2 Network
indication
4.1.3 How to Send
a message
4.1.4 Ways to send Ctrl +Z in Coolterm
4.1.5 How to Make a phone call
4.2 How to drive the GPS Mode via USB port
4.3 How to drive the GSM Mode via Arduino board
4.3.1 How to Send a message
4.3.2 How to Control your Arduino via SMS
4.3.3 How to Make a phone call
4.4 How to drive the GPS Mode via Arduino board
Introduction
This is a GPS/GPRS/GSM shield from DFRobot. This shield with a Quadband GSM/GPRS
engine works on frequencies EGSM 900MHz/DCS 1800MHz and GSM850 MHz/PCS 1900MHz.
It also supports GPS technology for satellite navigation. It's possible for your robot and control
system to send messages and use the GSM network.
It is controlled via AT commands(GSM07.07 ,07.05 and SIMCOM enhanced AT Commands).
And the design of this shield allows you to drive the GSM & GPS function directly with the
computer and the Arduino Board. It includes a highgain SMD antenna for GPS & GSM.
This GPS/GPRS/GSM shield uses an embedded SIM908 chip from SIMCom.Featuring an
industrystandard interface and GPS function, the combination of both technologies allows goods,
vehicles and people to be tracked seamlessly at any location and anytime with signal coverage.
Specification
Power supply: 612v
Low power consumption (100mA@7v GSM mode)
QuadBand 850/900/1800/1900MHz
GPRS multislot class 10
Support GPS technology for satellite navigation
Embeded highgain SMD antennas for GPS & GSM
Directly support 4*4 button pad
USB/Arduino control switch
Board Surface:Immersion Gold
Size: 81x70mm
