Hardware Installation
33
The system board supports 4 USB ports. USB allows data exchange
between your computer and a wide range of simultaneously
accessible external Plug and Play peripherals. You must have the
proper drivers installed in your operating system to use the USB
ports. Refer to your operating systems manual or documentation.
Two onboard USB ports (J9 - Black) are located at the ATX double
deck ports of the board.
Depending on the type of USB port cable that you are using, the
J21/J23 connector on the system board allows you to connect 2
more optional USB ports. These optional USB ports, which are
mounted on a card-edge bracket, will be provided as an option. If
you wish to use the optional USB ports, install the card-edge
bracket to the system chassis then insert the connector that is
attached to the USB port cables to J21/J23.
Insert the USB port cable connector to pins 1-10 if:
One of the holes on the cable connector is plugged, meaning the
cable connector has a keying mechanism.
Insert the USB port cable connector to pins 6-15 if:
None of the holes on the cable connector is plugged, meaning
the cable connector has no keying mechanism.
The system board supports the Wake-On-USB Keyboard function.
This function allows you to use a USB keyboard to wake up a
system that is in the S3 (STR - Suspend To RAM) state. If you want
to use this function, make sure USB KB Wake Up From S3 in the
Power Management Setup submenu of the BIOS is set to Enabled.
Refer to USB KB Wake-Up From S3 in the Power Management
Setup section in chapter 3 for more information.
This Manual: http://www.manuallib.com/file/2541789
