43
MODEM Use IRQ
This category is used to set an IRQ channel (IRQ 3, 4, 5, 7, 9, 10 or
11) for the modem installed in your system.
Doze
Mode
Standby
Mode
Suspend
Mode
HDD Off
After
PM Timers
These Green PC power saving categories are user configurable only
when the Power Management category is set to User Defined.
When enabled and after the set time of system inactivity, the
CPU clock will run according to the Doze speed that was set
in the "Doze Speed (div by)" category. All other devices still
operate at full speed.
When enabled and after the set time of system inactivity, the
CPU clock will run according to the Standby speed that was
set in the "Standby Speed (div by)" category. All other devices
still operate at full speed.
When enabled and after the set time of system inactivity, all
devices except the CPU will be shut off.
It is used to define the continuous HDD idle time that elapses
before the HDD enters the power saving mode (motor off).
When enabled and after the set time of system inactivity, the
hard disk drive will be powered down while all other devices
remain active.
PM Events and IRQ3-IRQ15
These are I/O events whose occurrence can prevent the system from
entering a power saving mode or can awaken the system from such a
mode. In effect, the system remains alert for anything which occurs to a
device which is configured as enabled, even when the system is in a
power saving mode.
When an I/O device wants to gain the attention of the operating system,
it signals this by causing an IRQ to occur. When the operating system
is ready to respond to the request, it interrupts itself and performs the
service. When set to Enable, the activity will neither prevent the system
from going into a power saving mode nor awaken it.
