www.d
fi
.com
27
Chapter 2 Hardware Installation
Chapter 2
S/PDIF Connector
The S/PDIF connector is used to connect an external S/PDIF port. Your S/PDIF port may be
mounted on a card-edge bracket. Install the card-edge bracket to an available slot at the rear
of the system chassis then connect the audio cable to the S/PDIF connector. Make sure pin 1
of the audio cable is aligned with pin 1 of the S/PDIF connector.
1
5
+5V
SPOUT Ground
SPIN
S/PDIF
Expansion Slots
PCI Express x16
Mini PCI Express & mSATA
(CS100-Q370/CS246)
mSATA
(CS100-H310)
Mini
PCI Express Slot
The full-size Mini PCIe socket supports the installation of a Mini PCIe card or an mSATA card.
To switch between these two signals, use JP2. Refer to the “Jumper Settings” section for more
information.
PCI Express x16 Slot
Install PCI Express x16 graphics card conformed to the PCI Express specifications, into the PCI
Express x16 slot. To install a graphics card into the x16 slot, align the graphics card above the
slot then press it down firmly until it is completely seated in the slot. The retaining clip of the
slot will automatically hold the graphics card in place.
