www.d
fi
.com
11
Chapter 2 Hardware Installation
Chapter 2
Jumper Settings
Panel Power Select
3
JP2
1
3
5
2
4
6
1
3
5
2
4
6
1-3 On: +5V
3-5 On: +3.3V
(default)
JP2 is used to select the power supplied with the LCD panel.
Important:
Before powering-on the system, make sure that the power settings of JP2 match the
LCD panel’s specification. Selecting the incorrect voltage will seriously damage the
LCD panel.
6. Push down the module until the clips at each end of the socket lock into position. You will
hear a distinctive “click”, indicating the module is correctly locked into position.
5. Grasping the module by its edges, align the module into the socket at an approximately 30
degrees angle. Apply firm even pressure to each end of the module until it slips down into
the socket. The contact fingers on the edge of the module will almost completely disappear
inside the socket.
Clip
Clip
