DFI AGP-7410, User Manual

Page: 9 / 12

9
AGP-7410 Graphics Card User’s Manual
After you plug the monitor cable into the VGA connector of the graphics
card, gently tighten the cable screws to hold the connector in place.
Note:
Some monitors have a switch that chooses between analog and TTL
(or digital) operation. If your monitor has such a switch, set it for
analog.
Operating System Requirements
To use all AGP features, your system must be installed with
Windows
®
95 OSR 2.1 or later versions, and DirectX5. If your
system is installed with Windows
®
95 OSR 2.0, you may upgrade it
to OSR2.1 by following the steps in the next section.
Upgrading Windows
®
95 OSR2.0 to OSR2.1
You must have OSR2.0 already installed before you can upgrade it
to OSR2.1. To determine the current version of OSR2.0 installed in
your system, please follow the steps below.
1. On the Windows
®
95 desktop, select “Start”.
2. In “Start”, select “Programs”.
3. In “Programs”, select “MS-DOS Prompt”.
4. Change the directory to the drive where Windows
®
95 is
installed and type “VER”. (e.g. C:\>VER)
5. The following will appear: Windows 95 [Version 4.00.1111].
6. Exit MS-DOS Prompt.
To upgrade OSR2.0 to OSR2.1 with the USB upgrade, please follow
the steps below.
1. On the Windows
®
95 desktop, select “Start”.
2. In “Start”, select “Run”.
3. In “Run”, select “Browse”. The USB upgrade is in
OSR2\USBSUPP\USBSUPP.EXE.
4. Follow the prompts to complete installation.
5. Click OK to restart your computer.