47
Auto
0-4
The BIOS will automatically set the system according to your
hard disk drives timing.
You can select a mode that matches your hard disk drives
timing.
Onboard FDC Controller
Enables the onboard floppy disk controller.
Disables the onboard floppy disk controller.
Enabled
Disabled
Onboard Serial Port 1 and Onboard Serial Port 2
Infra Red (IR) Function
The 586STC system board supports IrDA function for wireless connec-
tivity between your computer and peripheral devices. To use the IrDA
function, follow the steps below.
1. Connect your IrDA cable to connector J9 of the 586STC system
board. Refer to page 12 for the location of connector J9.
2. Set Infra Red (IR) Function to the type of IrDA standard supported
by your IrDA peripheral/device.
You may not use IrDA (J9) and the COM 2 serial port (J10) at the same
time. If you are using the COM 2 serial port, set Infra Red (IR) Func-
tion to Standard.
The system will automatically select an I/O address for the
onboard serial port 1 and serial port 2.
Allows you to manually select COM1, COM2, COM3, or
COM4 for the onboard serial port 1 and serial port 2.
Disables the onboard serial port 1 and/or serial port 2.
Auto
COM1 to
COM4
Disabled
Uses the COM 2 serial port.
HP mode IrDA.
SHARP mode IrDA.
Standard
HPSIR
ASKIR
