DEZAL-Pro WAFFLES 301, Manual, Page: 2 / 4

It is forbidden to:

leave unattended switched on or hot toaster while there are children, mentally handicapped and
animals in the vicinity;

leave switched on or hot toaster without an adult supervision;

immerse the toaster in water (even in part);

operate the toaster in explosive atmospheres;

operate the toaster with a damaged power cord;

perform any modification in the design of the toaster without the consent of the manufacturer;
The manufacturer is not liable for any damage arising from the use of the device for its unintended
purpose. The manufacturer is not liable for any damage arising from the operation of the damaged
device.
Handling:
Set the toaster on a flat level surface. Turn on the toaster by inserting the plug into the socket. Preheat
closed for approx. 6 – 8 min. Leaving the toaster closed for a long time without the dough is not
recommended. Open the toaster. The whole "squared" surface of both worktops coat with fat (e.g. with
vegetable oil) with a brush made of natural bristles. Put the appropriate amount of dough on the hot
bottom plate. Pouring too much dough will cause its flow out of the toaster. You should put the dough
only on the "squared" part of the bottom plate. After pouring the dough, close the toaster as soon as
possible. After 4 – 6 minutes, open the toaster and remove baked waffles. After cooking, turn off the
toaster by removing the plug from the socket. Leave to cool down.
We recommend using e.g. wooden sticks to remove the waffles. Using metal tools can damage the
coating of the plates.
Do not open the toaster in the initial stage of baking because of the possibility of waffles damage.
Checking the status of baking may take place when the amount of water vapour is clearly reduced and
the top plate went down somewhat.
When you turn on a new toaster, short-smoking may occur. This is normal due to the burning of the
technological residues and it does not cause any danger. During the warm-up and cool-down of the
toaster, crackling metallic noise may be heard. It is also normal, due to the thermal expansion of
elements.