Dexter Laundry T350, Parts & Service Manual

Page: 41 / 168

41
TEMPORARY DRYER CONTROLLER PROGRAMMING
Temporary programming mode will allow the change of the stored dry cycle settings in the dryer
controller for one complete dry cycle. After the dry cycle is complete, the default settings that existed be -
fore the temporary change are restored. The temporary dry cycle can be stopped and cleared at any time
during the dry cycle operation.
To temporarily change a dryer controller cycle, follow the procedures below. Things that are
displayed on the 4-digit numeric display will be in “quotation marks”. Touch pad switches on the dryer
controller that physically need to be pressed will be in CAPITAL AND BOLD LETTERS .
If, at any time, you want to escape the temporary programming mode while changing the program
settings, you can press the STOP touch pad switch on the dryer controller if the 4-digit numeric display is
not flashing. The SELECT/ENTER touch pad switch on the dryer controller can be pressed and released
to enter the flashing value shown on the 4-digit numeric display and allow you to escape.
If you press and release the STOP touch pad switch on the dryer controller, when the 4-digit
numeric display is not flashing, the temporary changes to the dry cycle program will be cancelled. The
stored dry cycle settings that existed before the temporary change will then be restored.
If, at any time, you want to start the temporary dry cycle during the temporary programming
mode, press and release the START touch pad switch on the dryer controller if the 4-digit numeric display
is not flashing. The SELECT/ENTER touch pad switch on the dryer controller can be pressed and re-
leased to enter the flashing value shown on the 4-digit numeric display and allow you to start the tempo -
rary dry cycle. If you start the temporary dry cycle, the 4-digit numerical display will change the total dry
time and count down to 0 as the dry cycle progresses.
PROCEDURE
1) Make sure the dryer is not in a dry cycle. The 4-digit numeric display on the dryer control
ler will show “LOAd” when the dryer is not in a dry cycle.
2) Press and release the UP or DOWN touch pad switch on the dryer controller to choose
the dry cycle that you want to change (dry cycle 1 through 5). The dry cycle
L.E.D. will illuminate to indicate which dry cycle you are choosing. If you press and hold
down either the UP or DOWN touch pad switch, the controller will sequence through the five dry
cycles.
3) Press and release the CYCLE touch pad switch on the dryer controller once you have
chosen the dry cycle you want to change. After you press the CYCLE touch pad switch,
the programming L.E.D. and the dry time L.E.D. will illuminate, the dry cycle L.E.D. will
remain illuminated, and the total dry time will be displayed on the 4-digit numeric display.
4) Press and release the UP or DOWN touch pad switch on the dryer controller to change
the total cycle time. Once either the UP or DOWN touch pad switch is pressed, the dry time
L.E.D. and the total dry time on the 4-digit numeric display will flash. If you press and
hold down either the UP or DOWN touch pad switch, you will increment ( UP arrow) or
decrement ( DOWN arrow) through the total dry times available (1 through 60 minutes). This dis
play dry time includes the cool down time along with the heated time. To not change the
cool down time , do not press either the UP or DOWN touch pad switch. Go to the next step.
Part # 8533-104-001 1/18