Dexter Laundry 350OS2.5, Instruction Manual

Page: 141 / 156

Hold the tool firmly to control the twisting of the tool.
To prolong the life of the tool never overload it.
Switch on and off
6. OPERATION
FR
ES
PT
IT
EL
PL
UA
RO
EN
141
WARNING: Before plugging the tool into the power point always
checks that the trigger switch work properly.
Switch the sander on by push the “I” mark on the on/off switch.
To turn off the sander, push the “O” mark.
The sander can be used for most sanding operations on materials such as wood, plastic,
metal and painted surfaces.
Sanding
WARNING : Don’t use this machine on plaster.
Wear safety goggles and dust mask.
WARNING : *When placing the sander in contact with the part, do not exert
excessive pressure. The pressure intensification does not lead to an increase in
the sanding capacity, but to a greater wear on the machine and on the
sanding sheet, as it can also reduce the sanding efficiency.
Where possible, secure smaller workpiece to prevent them from moving under the sander.
Lower the sander in contact with the workpiece without pressure and then start the sander.
Move the sander slowly over the surface of the workpiece in a circular or curved motion with
an even, moderate pressure.
If there are still scratches on your work after sanding, try either of the following:
- Go back to a coarser grit and sand the marks out before recommencing with the original
choice or,
- Try using new sanding sheet of the same grit to eliminate the unwanted marks before
progressing to a finer grit and finishing the job.