Dexter Laundry 20VMFS2.1, Warnings And Safety Instructions

Page: 83 / 92

FR
ES
PT
IT
EL
PL
UA
EN
RO
WARNING :
contain chemicals that can damage, weaken or destroy the housing, thus compromising the integrity of the double insulation.
B. REPLACING THE SANDING PAD
2. Untight and remove the screws holding the sanding pad in place.
4. Fasten the pad with the screws.
5. Press on a suitable sandpaper.
C. DUST EXTRACTION
The tool can be used with the dust collector or dust extractor. To use a dust extractor, do as follows :
1.Release the dust collector from the tool.
2. Put the adapter in the tool
3.Turn the adapter under clockwise to fasten it.
4. Connect the dust extractor to the adapter.
D. TRANSPORTATION CONDITIONS
WARNING : Do not use the dust extraction box when sanding metal.The hot metal particles could cause residual wood dust or the box itself to
catch fire.
A. ATTACHING SANDING PAPER
1. Select the required grade of sanding paper.
2. Remove any dust or debris from the hook and loop of the base with a soft brush.
3. To attach hook & loop sanding paper simply align the holes in the sanding paper with the holes in the sanding pad and press firmly into place.
4. To remove the sanding paper, peel it away from the pad.
NOTE : Hook and loop sanding pad is not a warranty item.
GRIT CHART
GRIT USE EXAMPLE OF USE
40 STRIPPING
Material removal, heavy paint removal, shaping wood
80 SANDING
Paint removal, rough surface preparation (e.g non-planed wood)
120 FINISHING
Surface preparation planed wood
Final finishing 180
9. MAINTENANCE
WARNING : Do not continue to use the sander with a sanding paper that is overworn or damaged. Do not use the same sanding paper for wood
and metal. Metal particles become embedded in the sanding paper and will scour a wooden surface. Take care to regularly clean out the buildup
of dust on the pad underneath the sanding paper and not to let the sanding paper wear completely down before replacing it. Failure to observe
these two precautionary measures can lead to damage to the hooks and loops on the pad and the sanding paper will not attach properly. Clean
the air vents on your power tool regularly. The motor’s fan will draw the dust inside the housing and excessive accumulation of powdered dust
may cause electrical or mechanical hazards.
FINE FINISHING
Transportation of products can be operate with any kind of closed transport, the packaging of the manufacture or without it, but in this case, the
product must be prevented from mechanical damage, precipitation, exposure to chemically active substances and compliance with precau-
tionary measures for the transport of fragile goods.