SIRIUSi-XHS®
TECHNICAL REFERENCE MANUAL
2.2. Connecting SIRIUSi-XHS®
In this chapter, you can see the basic instructions for connecting SIRIUSi-XHS® devices over 3.0 USB and
RJ-45 ethernet connection. Advanced connections are described in the following chapters.
Important
The XHS device is not supported on the Windows 7.
2.2.1. Connection over 3.0. USB
First connect the power supply cable (PS-120-L1B2f) to the PWR IN 2-pin LEMO 1B male connector. Then
connect the usb cable with the USB-C connector to the appropriate connector on the back of the XHS
device. Finally connect the other side of the USB cable with the USB-A connector to the PC. You can find
advanced connections in chapter
Image 2: USB connection
2.2.1.1. Sample rate limitation when connected with USB
When the device is connected via 3.0. USB all 8-channels can run with the 15MHz sample rate.
2.2.2. Connection over EtherNET
First connect the power supply cable (PS-120-L1B2f) to the PWR IN 2-pin LEMO 1B male connector. Then
connect the Ethernet Cable with RJ-45 connector to the appropriate GLAN connector on the back of the
XHS device. Finally connect the other side of the ethernet cable to the LAN port of PC.
Image 3: Connection over Ethernet
SIRIUSi-XHS® - V21-2
7/52
