17
English
Storage (Fig. A)
1. Empty the canister, refer to Empty Canister
under Operation.
2. Clean the vacuum inside and outside. Refer to
Cleaning.
3. Clean or replace filters, refer to Filters.
4. Store the suction hose and the power cord as
shown in the illustration. Place the unit in a dry
room and secure it from unauthorized use.
Blowing Feature (Fig. C)
Your vac contains a blowing feature. It has the
capability to blow sawdust and other debris. It can
be used to blow dust and debris out of garages or off
patios and driveways. Follow the steps below to use
your vac as a blower.
1. Locate blowing port on your vac.
2. Insert one end of the 48mm x 2.1m. hose
into the blowing port.
3. Turn vacuum “ON”.
Optional Accessories
WARNING:
Since accessories, other than those
offered by D
E
WALT, have not been tested with this
product, use of such accessories with this appliance
could be hazardous.
To reduce the risk of injury, only D
E
WALT
recommended accessories should be used with this
product.
CLEANING
TROUBLESHOOTING
WARNING!
TO REDUCE THE RISK OF INJURY FROM
MOVING PARTS AND/OR ELECTRICAL SHOCK,
TURN POWER SWITCH OFF AND DISCONNECT
GROUNDED PLUG FROM ELECTRICAL OUTLET
BEFORE PERFORMING TROUBLESHOOTING
CHECKS.
Minor problems often can be fixed without calling
customer service.
WARNING!
If the power cord is damaged, it must
be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
PROBLEM
SOLUTION
Motor does not run
Check power cord, plugs and outlet.
Ensure the on/off switch is in the
ON position ( I )
Remove blockages in the suction
nozzle, suction tube, suction hose
or filters.
Replace the paper or fleece bag.
Clean or replace the filters.
Empty canister, refer to
Empty
the tank
under
Operating.
instructions
Check for proper installation of the
filters.
Suction capacity
decreases
Vacuum stops
running
Thermal overload has been tripped:
1. Turn the vacuum off and
disconnect vacuum cleaner from
power source.
2. Empty the canister, if needed.
3. Allow the unit to cool.
4. Plug the power cord into an
appropriate outlet and turn on/off
switch to the ON position ( I ) to
test.
Ensure filters are not damaged;
replace if necessary.
Ensure filter seals are in place and
are secure.
Check for proper installation of the
filters.
Dust comes out
while vacuuming
To keep your wet/dry vac looking its best, clean the
outside with a cloth dampened with warm water and
mild soap.
To clean the tank:
1. Dump out debris.
2. Wash tank thoroughly with warm water and mild
soap.
3. Wipe out with dry cloth.
YEAR
LIMITED
GUARANTEE
3
TOOL GUARANTEE
