DeWalt DXGHT22, Operator'S Manual

Page: 13 / 96

13
ENGLISH
4. Push the attachment straight into the
coupler (Fig. 2) until the release button
snaps firmly into the 90˚ hole (Fig. 3).
5. Turn the knob clockwise to tighten the
coupler (Fig. 1).
Removing the Attachment
1. Set the unit on a flat, level surface.
2. Turn the knob counterclockwise to loosen
the coupler (Fig. 1).
3. Press and hold the release button (Fig. 3).
4. Pull the attachment straight out of the
coupler (Fig. 2).
ASSEMBLY
Installing and Removing the
Attachment
The coupler enables the use of various optional
attachments.
Installing the Attachment
1. Remove the hanger cap from the
attachment. Keep the hanger cap for use
when storing the attachment. If present,
remove the gray spacer from the coupler.
2. Set the unit on a flat, level surface.
3. Turn the knob counterclockwise to loosen
the coupler (Fig. 1).
WARNING:
Before using any
attachment, read and understand
the manual that came with the
attachment. Follow all safety
information contained within.
WARNING:
To avoid serious
personal injury and damage to the
unit, shut the unit off before
removing or installing an attachment.
WARNING:
Before operating the
unit, make sure the release button is
fully snapped into the 90˚ hole and
the knob is securely tightened.
WARNING:
Unless specified
otherwise, the release button should
be snapped into the 90˚ hole only.
Using the wrong hole could lead to
personal injury or damage to the unit.
Fig. 1
Knob
Tighten
Loosen