DeWalt DXFRS300, Owner'S Manual

Page: 6 / 12

To Adjust Volume
1. Rotate clockwise to increase the volume.
2. Rotate counterclockwise to decrease the volume.
Do not hold the radio close to your ear. If the volume is set to an
uncomfortable level, it could hurt your ear.
5 6
Call Button
Press and release the Call/Lock button.
The other person will hear a three second call
tone. This tone is used only to establish voice
communications.
Lock Function
The
Lock
function locks the
Up, Down
and
Mode
buttons to prevent accidental operation.
To turn the lock on or off:
– Press and hold the
Call/Lock
button for
two seconds.
A double beep sound is used to confirm your lock
enabled . When in Lock mode, the Lock icon will be
displayed also.
Range
Your range will vary depending on terrain and
conditions.
In flat, open country your radio will operate at
maximum range.
Buildings and foliage in the path of the signal can
reduce the range of the radio.
Dense foliage and hilly terrain will further reduce the
range of the radio.
On Channels 8 through 14, your radio automatically
switches to low power, which will limit the range the
radio can communicate.
Auto Squelch
Your radio will automatically shut off weak transmissions and unwanted
noise due to terrain, conditions limit.
Call Button
Lock Button
Lock Icon
Communicating with Another Person
1. Press and hold the Talk button.
2. Position the microphone about two inches (5 cm)
from your mouth, speak in a normal voice.
3. Release the Talk button when you are finished
talking and listen for a response.
You cannot receive incoming calls while pressing the
Talk button.
To Select a Channel
Press
Mode
button once, then press
Up
button or
Down
button.
Two Inches
from Mouth
Both radios must be tuned to the
same channel to communicate.
See
page 13
for frequency
allocations charts.
Listening for a Response
Release the
Talk
button to receive incoming
transmissions. Your radio is always in
Standby
mode
while the
Talk
or
Call
buttons are not pressed.
Up & Down Button
Talk Button
Channel Number
Listening
Both radios must be tuned to the same
channel and privacy code to communicate.
This radio is equipped with default Privacy Code on each
channel for minimizing unwanted signals from others. See page
9 to 10 for procedures changing your radio from default Privacy
Code to a different Privacy Code or disabling Privacy Code.