-13-
MAINTENANCE CHECKLIST
Maintenance
Benefit
Procedure
Service Interval
Inspect trigger performance
Ensure trigger system is in
proper working order
Refer to Tool Operation Check
section in this manual
Daily
Drain condensation from air
compressor tanks and air filters
(if present)
Prevents accumlation of
moisture that can impede tool
performace
Open drain cock on tanks and air
filters and drain all condensate
Daily
Clean magazine assembly
Prevents accumlation of debris
that could cause a jam
Blow clean with compressed air
Daily
Clean nose assembly
Prevents accumlation of debris
that could cause a jam
Blow clean with compressed air
Daily
Ensure all fasteners remain tight
Prevent loose parts
Tighten all fasteners with
appropriately sized hex wrench
Weekly
Replace air fitting
Maintains proper air flow to
engine for peak performance
Remove worn air fitting and
replace with new fitting
50,000 Fasteners
Replace piston/driver assembly
Maintains consistent drive
quality
Refer to replacement part kit
instructions
150,000 Fasteners
Replace O-rings
Maintains engine for peak
performance
Refer to replacement part kit
instructions
250,000 Fasteners
Replace bumper
Maintains engine for peak
performance
Refer to replacement part kit
instructions
250,000 Fasteners
Replace headvalve
Maintains engine for peak
performance
Refer to replacement part kit
instructions
250,000 Fasteners
Replace engine cylinder
Maintains engine for peak
performance
Refer to replacement part kit
instructions
500,000 Fasteners