English
6
4. To remove the tuckpoint shroud, loosen the collar
screw, rotate the tuckpoint shroud to align the slots and
tabs and pull up on the tuckpoint shroud.
nOTE:
The tuckpoint shroud is pre-adjusted to the diameter
of the gear case hub at the factory. If, after a period of time,
the tuckpoint shroud becomes loose, tighten the collar
screw
9
.
NOTICE:
If tuckpoint shroud cannot be secured by
tightening the collar screw, do not use tool. Take the tool and
tuckpoint shroud to a service center to repair or replace the
tuckpoint shroud.
Flanges and Wheels (Fig. C, D)
CAUTION:
Turn unit off and unplug the tool before
making any adjustments or removing or installing
attachments or accessories.
WARNING:
Failure to properly seat the flanges and/or
wheel could result in serious injury (or damage to the
tool or wheel).
WARNING:
Only Type 1 Diamond Wheels shall be
used with Tuck-Point Shroud
. Do not cut metal. Do
not use with bonded abrasive wheels.
WARNING:
A closed, two-sided cutting wheel guard
is required when using abrasive cutting wheels or
diamond coated cutting wheels.
WARNING:
Use of a damaged flange or guard or fail-
ure to use proper flange and guard can re sult in injury
due to wheel breakage and wheel contact. See the
Accessories Chart
for more information.
It may be necessary to open the cornering door to install
6" (152.4 mm) tuckpointing wheels, see
Cornering
Door Application.
1. Place the tool on a table, guard up.
2. Install the unthreaded backing flange
3
on spindle
1
with the raised center (pilot) facing the wheel.
3. Place wheel
14
against the backing flange,
centering the wheel on the raised center (pilot) of the
backing flange.
4. While depressing the spindle lock button and with the
hex depressions facing away from the wheel, thread the
threaded locking flange
4
on spindle so that the lugs
engage the two slots in the spindle.
5.
nOTE:
If the wheel you are installing is more than 1/8"
(3.17 mm) thick, place the threaded locking flange on
the spindle so that the raised section (pilot) fits into the
center of the wheel. If the wheel you are installing is
1/8" (3.17 mm) thick or less, place the threaded locking
flange on the spindle so that the raised section (pilot) is
not against the wheel.
Fig. C
Over 1/8" (3.17 mm)
wheels
Backing Flange
Locking flange
1/8" Or less (3.17 mm)
wheels
Backing Flange
Locking flange
6. While depressing the spindle lock button, tighten the
threaded locking flange
4
:
-
Tighten standard threaded locking flange using
a wrench
18
.
7. To remove the wheel, depress the spindle lock button
and loosen the threaded locking flange.
Fig. D
18
4
14
3
1
Depth of Cut Adjustment (Fig. E)
1. Loosen the depth of cut shoe locking knob
11
.
2. Slide the depth of cut shoe
10
to the desired position.
3. Tighten depth of cut shoe locking knob.
Fig. E
10
11
Corner Door Application (Fig. F)
WARNING: To reduce the risk of injury, ALWAYS
turn off tool and disconnect the tool from the
power source before making any adjustments
or removing or installing attachments or
accessories. This applies to both the grinder and
the dust extractor vacuum.
Such preventative
safety measures reduce the risk of starting the
tool accidentally.
