ENGLISH
38
WARNING:
Use only D
E
WALT battery
packs and chargers.
Inserting and Removing the
Battery Pack from the Tool (fi g. A, B)
WARNING: To reduce the risk of
serious personal injury, turn tool off
and disconnect battery pack
before
making any adjustments or removing/
installing attachments or accessories.
An accidental start-up can cause injury.
TO INSTALL THE BATTERY PACK INTO THE TOOL HANDLE
1. Align the base of the tool with the notch inside
the tool’s handle (fig. B).
2. Slide the battery pack firmly into the handle until
you hear the lock snap into place.
TO REMOVE THE BATTERY PACK FROM THE TOOL
1. Press the release buttons (7, fig. A) and firmly
pull the battery pack out of the tool handle.
2. Insert battery pack into the charger as
described in the charger section of this manual.
Inserting and Removing Bits (fi g. A)
• Open the chuck (4) by turning the sleeve (5)
counterclockwise and insert the bit shank.
• Place the bit in the chuck as far as it will go
andlift slightly before tightening.
• Tighten firmly by turning the sleeve clockwise
whileholding the rear part of the chuck with one
hand.
• To remove the bit, proceed in reverse order.
Forward/reverse Switch (fi g. A)
• To select forward or reverse rotation, use the
forward/reverse slider (2) as shown (see arrows
on tool).
WARNING:
Always wait until the motor
has come to a complete standstill
before changing the direction of rotation.
Two Gear Selector (fi g. C)
Your tool is fitted with a two gear selector (3) to vary
the speed/torque ratio.
1 low speed/high torque
(drilling large holes, driving screws)
2 high speed/low torque
(drilling smaller holes)
For speed rates, refer to the technical data.
WARNING:
Do not change gears at full
speed or during use.
NOTICE:
Always push the two
gear selector completely forward or
backward.
Removing and Fitting the Chuck
(fi g. D, E)
• Open the chuck jaws as far as possible.
• Insert a screwdriver into the chuck and remove
the chuck retaining screw (12) by turning
clockwise as shown in figure D.
• Tighten an Allen key into the chuck and strike
it with a hammer as shown in figure E. This will
loosen the chuck so that it can be unscrewed
by hand.
• To refit the chuck, proceed in reverse order.
OPERATION
Instructions for Use
WARNING:
•
Always observe the safety instructions
and applicable regulations.
•
Be aware of the location of pipework and
wiring.
•
Apply only a gentle pressure to the tool.
Excessive force does not speed up drilling
but decreases tool performance and may
shorten tool life.
•
To minimise stalling on break-through,
progressively reduce the drill point
pressure towards the end of the
operation.
•
Keep the motor running when pulling
thebit back out of a drilled hole. This will
help prevent jamming.
PRIOR TO OPERATION
• Make sure your battery pack is (fully) charged.
• Insert the appropriate bit.
• Mark the spot where the hole is to be drilled.
• Select forward or reverse rotation.
Proper Hand Position (fi g. F)
WARNING:
To reduce the risk of
serious personal injury,
ALWAYS
use proper hand position as shown.
Summary of Contents for DW955
