• Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath
of the cable firmly and that the leads are correctly fixed at the terminal screws.
1
2
4
3
WARNING:
Never use a light socket. Never connect the live (L) or neutral (N) wires to the earth pin
marked E or .
For 115 V units with a power rating exceeding 1500 W, we recommend to fit a plug to BS4343 standard.
Using an extension cable
If an extension cable is required, use an approved extension cable suitable for the power input of this machine
(see technical data). The minimum conductor size is 1.5 mm
2
.
When using a cable reel, always unwind the cable completely.
Also refer to the table below.
Conductor size (mm
2
)
Cable rating (Amperes)
0.75
6
1.00
10
1.50
15
2.50
20
4.00
25
Cable length (m)
7.5
15
25
30
45
60
Voltage
Amperes Cable rating (Amperes)
230
0
-
2.0
6
6
6
6
6
6
2.1 -
3.4
6
6
6
6
6
6
3.5 -
5.0
6
6
6
6
10
15
5.1 -
7.0
10
10
10
10
15
15
7.1 - 12.0
15
15
15
15
20
20
12.1 - 20.0
20
20
20
20
25
-
ASSEMBLY AND ADJUSTMENT
WARNING:
Prior to assembly and adjustment always unplug the tool.
The machine is fully assembled except for the blade, rip fence, upperblade guard and table insert.
Fitting the Rip Fence (fig. B1, B2)
The rip fence (7) can be installed on the left- or right-side of your table saw.
1. Locate the pin (19) with the slot (20) in the rip fence and align the opening (21) with the rip fence latch (22)
(fig. B1, B2).
2. Secure the rip fence by snapping both latches in place (fig. B2).
Mounting the Saw Blade (fig. A1, C1, C2)
WARNING:
Ensure the machine is disconnected from the power source.
B1
B2
C1
C2
WARNING:
The teeth of a new blade are very sharp and can be dangerous.
1. Raise the blade arbor to its maximum by rotating the control wheel (10) clockwise (fig. A1).
2. Place the saw blade onto the spindle in the order shown in figure C1. Make sure the teeth point down at the
front of the table.
3. Hold the spindle using the open-ended wrench and tighten the arbor nut by rotating clockwise using the arbor
wrench (fig. C2).
4. To remove the blade, proceed in reverse order.
WARNING:
Always check the rip fence pointer and the riving knife after having changed the blade.
4
