9
E
Using the Tool
Lining up Tiles on a Floor
1.
Position the tool on the smooth, flat floor where
you are ready to begin placing tiles.
2.
Press the Power
button
(Figure
A
1
) to
display the horizontal and vertical laser lines.
3.
Line up your tiles along the laser lines (Figure
C
).
4.
Once you have placed all the tiles that will fit along
the current laser lines, reposition the tool for the
next tiles to be placed on the floor.
5.
When you are finished using the tool, press the
Power
button
to turn off the laser lines.
Lining up Objects on a Wall
1.
Position the tool on the smooth, flat wall where
you are ready to place tiles, pictures, or other
objects.
2.
Press the Power
button
(Figure
A
1
) to
display the horizontal and vertical laser lines.
3.
Use the Level Vials to make sure the horizontal
laser line is level on the wall.
• Use Level Vial
A
4
to level laser line
A
3
horizontally on the wall.
• Use Level Vial
A
6
to level laser line
A
2
horizontally on the wall.
• Use Level Vial
A
5
to correctly position the
laser lines at a 45° angle on the wall.
4.
Use the 2 connected push pins and/or the third
push pin on the bottom of the tool to attach the
tool to the wall. The pins can be pushed straight in
or at an angle into the wall (Figure
E
).
• To use the 2 connected push pins on the top of
the tool, lift them up and then push them into the
wall (Figure
D
2
and
D
3
).
• To use the third push pin on the bottom of the
tool, pull it up and out of the tool. Then push
it through any of the 3 outer holes (Figure
A
9
-
11
).
5.
Line up your objects on the wall.
6.
If you need to place more objects on the wall,
remove the pins and reposition the tool on the wall
as you did before.
7.
When you are finished using the tool, press the
Power
button
to turn off the laser lines.
Maintenance
• When the tool is not in use, clean the exterior parts
with a damp cloth, wipe the tool with a soft dry cloth
to make sure it is dry, and then store the tool in the
pouch provided.
• Although the tool exterior is solvent resistant,
NEVER use solvents to clean the tool.
• Do not store the tool at temperatures below -16 ˚F
(-25 ˚C) or above 158 ˚F (70 ˚C).
• To maintain the accuracy of your work, check the
tool often to make sure it is properly calibrated.
• Calibration checks and other maintenance repairs
may be performed by D
E
WALT service centers.
