DeWalt DE8201, Manual

Page: 11 / 64

11
E N G L I S H
en - 2
4 Wear safety goggles
Also use a face or dust mask in case the
operations produce dust or flying particles.
5 Beware of maximum sound pressure
Take appropriate measures for the protection of
hearing if the sound pressure of 85 dB(A) is
exceeded.
6 Stay alert
Watch what you are doing. Use common sense.
Do not operate the tool when you are tired.
7 Use appropriate tool
The intended use is laid down in this instruction
manual. Do not force small tools or attachments
to do the job of a heavy-duty tool. The tool will
do the job better and safer at the rate for which it
was intended.
Warning! The use of any accessory or attachment
or performance of any operation with this tool,
other than those recommended in this instruction
manual may present a risk of personal injury.
8 Have your Power Tool Attachment repaired
by an authorized D
E
WALT repair agent
Repair of your Power Tool Attachment being a
matter of precision and skill, always take it to
your D
E
WALT Authorized Repair Agent.
Diamond cutting discs
Observe the applicable regulations for diamond
cutting discs. Pay special attention to the following:
1 Remember that the general regulations regarding
diamond cutting discs prescribe the use of a
special guard.
2 Always check that the diamond cutting disc suits
the tool and attachment being used. Check disc
dimensions (diameter, thickness, etc). Make sure
that the diamond cutting disc is suitable for the
material to be cut.
3 Never use diamond cutting discs in the presence
of inflammable materials.
4 To avoid the risk of breakage, the location hole of
the diamond cutting disc must not be widened.
5 Always perform a test run under no load
condition before using a new cutting disc.
For safe operation and optimal results, also refer to
your angle grinder instruction manual.
Package contents
The package contains:
1 Diamond guard
1 Adaptor kit (DE8201 only)
4 screws
1 adaptor plate for DW811, DW816
1 adaptor plate for DW401, DW448, DW450(K),
DW451K, DW452(K), DW458(K), DW806 and
corresponding spacer
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fig. A)
Your diamond guard has been designed for use in
combination with diamond cutting discs. It combines
efficient dust extraction and accurate depth
adjustment.
DE8201: for angle grinders DW401, DW448,
DW450, DW451, DW456, DW458, DW806
& DW830.
DE8501: for angle grinders DW476, DW479,
DW490 & DW492.
1 Front plate
2 Rear plate
3 Base plate
4 Adaptor plate
5 Dust extractor outlet
6 Depth adjustment star grip
7 Spring
8 Screws
9 Lock nut (DE8501)
10 Slots (DE8501)
11 Side handle position
12 Guiding notch
13 Locking screws