DeWalt DE0892-XE, Instruction Manual

Page: 6 / 8

4
MAINTENANCE
Your attachment has been designed to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory operation depends upon proper
tool care and regular cleaning.
Detector Service
Except for batteries, there are no user serviceable parts in the Digital Laser Detector.
Do not disassemble the unit. Unauthorised tampering with the laser detector will void
all warranties.
Detector Cleaning and Storage
• Dirt and grease may be removed from the exterior of the detector using a cloth or
soft, non-metallic brush.
• The D
E
WALT digital laser detector is rain resistant but not immersible. Do not
pour water on the unit or submerge it under water.
• The best storage place is one that is cool and dry—away from direct sunlight
and excess heat or cold.
Detector Troubleshooting
THE DETECTOR WILL NOT TURN ON
• Press and release the power button.
• Check to see that the battery is in place and in the proper position.
• If the detector is very cold, allow it to warm up in a heated area.
• Replace the 9-volt battery. Turn the unit on.
• If the detector still does not turn on, take the detector to a D
E
WALT service
centre.
THE DETECTOR’S SPEAKER MAKES NO SOUND
• Ensure that the detector is on.
• Press the volume button. It will toggle on and off.
• Ensure that the laser is turned on and that it is emitting a laser beam.
• If the detector is still not making any sound, take it to a D
E
WALT service centre.
Mounting on a Grade Rod (Fig. 1, 2)
1. To secure your detector to a grade rod, first attach the detector to the clamp by
pushing in on the clamp latch (J). Slide the tracks (K) on the clamp around the
rail (L) on the detector until the latch (M) on the clamp pops into the latch hole
(N) on the detector.
2. Open the jaws of the clamp by turning the clamp knob (O) counterclockwise.
3. Position the detector at the height needed and turn the clamp knob clockwise to
secure the clamp on the rod.
4. To make adjustments in height, slightly loosen the clamp, reposition and
retighten.
J
M
K
O
FIG. 2