48
EnGLIsh
While offering the ability to drive more pins in less time, this
mode quickly depletes the battery charge.
1. Using the mode selector switch
4
to select the RapidCycle
mode.
2. Release the trigger lock-off
2
.
3. Push the contact trip
6
against the work surface.
4. Pull the trigger switch
1
to actuate the tool.
5. Release the trigger and raise the nailer from the work
surface.
nOTE:
The tool motor returns to full speed
automatically without the contact trip
6
being depressed.
6. Repeat steps 3–5 to actuate the next nail.
Pin/Fastener Troubleshooting
Properly driven pin
Over driven pin
CONCRETE
Pin does not hold in the concrete.
Cause:
-
Too hard/high strength
concrete
-
Hard or large aggregate
in concrete
Action:
-
Use shorter pin.
-
Switch to higher speed setting.
Pin does not drive deep enough.
Cause:
-
Pin too long
-
Speed setting too low
Action:
-
Use shorter pin.
-
Switch to higher speed setting.
Pin drives too deep.
Cause:
-
Pin too short for application
-
Speed setting too high
Action:
-
Use longer pin.
-
Switch to lower speed setting.
Pin bends.
Cause:
-
Pin hit large aggregate on entry
-
Too hard/high strength
concrete
-
Pit hit rebar just under surface
Action:
-
Use shorter pin.
-
Make sure nailer is
perpendicular to the work
surface.
-
Move 8 cm and try again.
STEEL
Pin does not penetrate the surface.
Cause:
-
Speed setting too low
-
Material to hard for pin type
Action:
-
Increase tool speed setting
Pin breaks or bends.
Cause:
-
Pin too long
-
Speed setting too low
-
Material to hard for pin type
Action:
-
Use shorter pin.
-
Switch to higher speed setting.
Pin does not hold in the steel.
Cause:
-
Steel base material too thin
Action:
-
Use alternative means to secure
base material.
Headlights/LED Indicator (Fig. A)
There are low battery and jam/stall indicator lights
9
located on
the front of the tool on each side of the magazine.
LOW BaTTERY
Replace battery with a charged pack.
hOT Pack
Let the battery cool or replace it with a
cool pack.
JaM/sTaLL cOnDITIOn
Rotate the stall release lever to release.
Refer to
Stall Release
or
Clearing a
Jammed Pin
.
