50
EnGLIsh
TROUBLESHOOTING
Problem
Solution
Unit will not start.
• Check battery installation.
• Check battery
charging requirements.
• Check that lock off is fully pushed
down prior to moving main trigger.
Unit shuts down
in use.
• Charge battery.
• Unit is being forced. Restart and
apply less pressure.
Battery
won’t charge.
• Insert battery into charger until red
charging light illuminates. Charge up
to 8 hours if battery is totally drained.
• Plug charger into a working outlet.
Refer to
Important Charging Notes
for more details.
• Check current at receptacle by
plugging an appliance.
• Check to see if receptacle is
connected to a light switch which
turns power off when you turn out
the lights.
• Move charger and appliance to
a surrounding air temperature of
above 4.5 °C or below 40.5 °C.
Bar /
Chain overheated.
• Refer to
Adjusting Chain
Tension
section.
• Refer to
Chain Oiling
section.
Chain is loose.
• Refer to
Adjusting Chain
Tension
section.
Poor cut quality.
• Refer to
Adjusting Chain
Tension
section.
nOTE:
Excessive
tension leads to excessive wear and
reduction in life of bar and chain.
Lubricate before each cut. Refer to
Replacing the Saw Chain
section.
Unit runs but does
not cut.
• Chain could be installed backwards.
Refer to sections for installing and
removing chain.
Unit does not oil.
• Refill oil reservoir.
• Clean guide bar, sprocket and
sprocket cover. Refer to
Care And
Maintenance
section.
Summary of Contents for DCM565
Page 1: ...DCM565 Final page size A5 148mm x 210mm ...
Page 3: ...1 1 2 3 4 5 6 7 8 9 10 12 13 14 15 11 16 Fig A Fig B Fig C Fig D 7 15 7 15 ...
Page 4: ...2 Fig I Fig E Fig F Fig G Fig H Fig J Fig K Fig L 17 18 19 20 16 10 12 13 ...
Page 5: ...3 60 0 635mm Fig Q Fig M Fig N Fig O Fig P Fig R Fig S Fig T 21 2 1 3 13 ...