DeWalt DCL030-XE, Instruction Manual

Page: 10 / 12

8
WARNING: Never use solvents or other harsh chemicals for cleaning the
non-metallic parts of the tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with water and mild soap. Never let
any liquid get inside the tool; never immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC outlet before
cleaning. Dirt and grease may be removed from the exterior of the charger using a
cloth or soft non-metallic brush. Do not use water or any cleaning solutions.
Repairs
The charger and battery pack are not serviceable. There are no serviceable parts
inside the charger or battery pack.
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should be performed by certified
service centers or other qualified service organizations, always using identical
replacement parts.
ACCESSORIES
WARNING: Since accessories, other than those offered by D
E
WALT, have not been
tested with this product, use of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
E
WALT, recommended accessories should be used
with this product.
Recommended accessories for use with your tool are available at extra cost from
your local service center. If you need any assistance in locating any accessory, please
contact Stanley Black & Decker, 82 Taryn Drive, Epping, VIC 3076 Australia or call
1800 444 224 or (NZ). 0800 339 258.
CAUTION: Only use the belt hook or the loop (B) for
FIG. 5
B
hanging the LED worklight. The belt hook and loop are not
intended to support additional weight. Do not attach or hang
anything additional to the light or risk of breakage may occur.
CAUTION: Do not use the belt hook or loop to reach with
or to support your weight in any situation.
LOOP (FIG. 2, 5)
The light may be carried or hung by the loop (B). When not
in use, the loop may be folded down.
BELT HOOK (OPTIONAL ACCESSORY) (FIG. 2)
WARNING: To reduce the risk of serious personal injury,
ensure the screw holding the belt hook is secure.
IMPORTANT:
When attaching or replacing the belt hook (F),
use only the screw (G) that is provided. Be sure to securely
tighten screw.
The belt hook (F) can be be attached to either side of the
light using only the screw (G) provided, to accommodate left- or right-handed users.
If the hook is not desired at all, it can be removed from the light.
To move belt hook, remove the screw (G) that holds the belt hook in place, then
reassemble on the opposite side. Be sure to securely tighten screw.
MAINTENANCE
WARNING: To reduce the risk of serious personal injury, turn light off and
disconnect tool from power source before making any adjustments or removing/
installing attachments or accessories.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air at least once
a week. To minimize the risk of eye injury, always wear AS/NZS51337 approved eye
protection when performing this.