11
English
4. Slide the sheath (G) over the blade until it snaps into place as
shown in Figure 11.
replacing Blade (fig. 1, 12–14)
WARNING:
Sharp
FIG. 12
12A
12A
12B
12D
12C
edges. Wear gloves when performing
any maintenance on the trimmer blade.
Follow the instructions below to replace
the blade (F) or bring the trimmer
to a D
e
WALT factory service center,
a D
e
WALT authorized service center,
or other qualified service personnel.
Always use identical replacement parts.
BLaDe reMoVaL
1. Remove battery.
2. Using a 4 mm hex bit, remove the
four cover screws (12A) and long blade/cover screw and washers
(12B) as shown in Figure 12. Retain screws and washers.
3. Pry the cover (12C) off by placing a flathead screwdriver under the
back of the cover (12D) and twisting.
4. Fully remove the blade
FIG. 13
13A
13C
13B
screw and washers
(13A), lift the front of the
blade (F) to disengage it
from the connection rod
(13B) and pull the blade
out of the trimmer.
5. Remove the top
connection rod (13B) by
DANGER:
KEEP HANDS AWAY FROM BLADES.
WARNING:
To guard against injury, observe the
following:
• READ INSTRUCTION MANUAL BEFORE USING. SAVE
INSTRUCTION MANUAL.
• Check the hedge for foreign objects such as wires or fences before
each use.
• KEEP HANDS ON HANDLES. DON’T OVERREACH.
• DO NOT USE UNDER WET CONDITIONS.
CAUTION
:
BLADE MAY COAST AFTER TURN OFF.
MAinTenAnce
WARNING:
Remove battery pack before servicing,
cleaning or removing material from the hedge trimmer.
Your D
e
WALT tool has been designed to operate over a long period
of time with minimum maintenance.
Continuous satisfactory operation depends on proper tool care and
regular cleaning.
WARNING:
Before performing any maintenance,
switch off tool and remove battery.
Lubrication (fig.11)
1. After use, carefully clean the blades
FIG. 11
G
with a resin solvent.
2. After cleaning, apply a light film of
lubrication to the exposed blade.
3. Turn the trimmer vertical with the
blades toward the ground and run
the trimmer for a few seconds to fully disperse the lubrication.
Summary of Contents for DCHT860
Page 2: ......
