6
WARNING:
Burn hazard. Battery liquid may be flammable if exposed to spark or
flame.
Important Safety Instructions for All Battery Chargers
SAVE THESE INSTRUCTIONS:
This manual contains important safety and operating
instructions for battery chargers.
• Before using the charger, read all instructions and cautionary markings on the
charger, battery pack and product using the battery pack.
WARNING:
Shock hazard. Do not allow any liquid to get inside the charger. Electric
shock may result.
CAUTION:
Burn hazard. To reduce the risk of injury, charge only D
E
WALT
rechargeable battery packs. Other types of batteries may overheat and burst resulting
in personal injury and property damage.
NOTICE:
Under certain conditions, with the charger plugged into the power supply, the
charger can be shorted by foreign material. Foreign materials of a conductive nature,
such as, but not limited to, grinding dust, metal chips, steel wool, aluminum foil or any
buildup of metallic particles should be kept away from the charger cavities. Always
unplug the charger from the power supply when there is no battery pack in the cavity.
Unplug the charger before attempting to clean.
•
DO NOT attempt to charge the battery pack with any chargers other than the
ones in this manual.
The charger and battery pack are specifically designed to
work together.
•
These chargers are not intended for any uses other than charging D
E
WALT
rechargeable batteries.
Any other uses may result in risk of fire, electric shock
or electrocution.
•
Do not expose the charger to rain or snow.
•
Pull by the plug rather than the cord when disconnecting the charger.
This will
reduce the risk of damage to the electric plug and cord.
•
Make sure that the cord is located so that it will not be stepped on, tripped
over or otherwise subjected to damage or stress.
•
Do not use an extension cord unless it is absolutely necessary.
Use
of improper extension cord could result in risk of fire, electric shock or
electrocution.
•
When operating a charger outdoors, always provide a dry location and use an
extension cord suitable for outdoor use.
Use of a cord suitable for outdoor use
reduces the risk of electric shock.
•
Do not place any object on top of the charger or place the charger on a soft
surface that might block the ventilation slots and result in excessive internal
heat.
Place the charger in a position away from any heat source. The charger is
ventilated through slots in the top and the bottom of the housing.
•
Do not operate the charger with a damaged cord or plug.
•
Do not operate the charger if it has received a sharp blow, been dropped or
otherwise damaged in any way.
Take it to an authorized service center.
•
Do not disassemble the charger; take it to an authorized service center when
service or repair is required.
Incorrect reassembly may result in a risk of electric
shock, electrocution or fire.
•
Disconnect the charger from the outlet before attempting any cleaning. This
will reduce the risk of electric shock.
Removing the battery pack will not reduce
this risk.
•
NEVER
attempt to connect 2 chargers together.
•
The charger is designed to operate on standard 230 V household electrical
power. Do not attempt to use it on any other voltage.
This does not apply to the
vehicular charger.
Chargers
Your tool uses a D
E
WALT charger. Be sure to read all safety instructions before using
your charger. Consult the chart at the end of this manual for compatibility of chargers
and battery packs.
Charging Procedure (Fig. 1)
FIG. 1
G
1. Plug the charger into an appropriate outlet before
inserting the battery pack.
2. Insert the battery pack (G) into the charger, as
shown in Figure 1, making sure the pack is fully
seated in charger. The red (charging) light will blink
continuously, indicating that the charging process
has started.
Summary of Contents for DCH253-XE
Page 1: ...DCH253 XE DCH254 XE HEAVY DUTY 18V CORDLESS ROTARY HAMMER INSTRUCTION MANUAL ...
Page 2: ......
Page 15: ......