DeWalt DCF899, Original Instructions Manual

Page: 40 / 168

38
english
Optional Accessories
WARNING: Since accessories, other
than those offered by D
e
WALT , have not
been tested with this product, use of
such accessories with this tool could be
hazardous. To reduce the risk of injury,
only D
e
WALT recommended accessories
should be used with this product.
WARNING: To reduce the risk of
injury, only use D
e
WALT impact-ready
accessories.
WARNING: Use only impact
accessories. Non-impact accessories
may break and cause a hazardous
condition. Inspect accessories prior
to use to ensure that they con tain no
cracks.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. Products and
batteries marked with this symbol must
not be disposed of with normal
household waste.
Products and batteries contain materials
that can be recovered or recycled reducing the
demand for raw materials. Please recycle electrical
products and batteries according to local provisions.
Further information is available at www.2helpU.com .
Rechargeable Battery Pack
This long life battery pack must be recharged when
it fails to produce sufficient power on jobs which
were easily done before. At the end of its technical
life, discard it with due care for our environment:
• Run the battery pack down completely, then
remove it from the tool.
• Li-Ion cells are recyclable. Take them to your
dealer or a local recycling station. The collected
battery packs will be recycled or disposed of
properly.
WARNING: To reduce the risk
of serious personal injury, place
the forward/reverse button in
the lock-off position or turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories.
An accidental start-up can
cause injury.
The charger and battery pack are not serviceable.
There are no serviceable parts inside.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING:
Shock hazard. Disconnect
the charger from the AC outlet before
cleaning. Dirt and grease may be
removed from the exterior of the charger
using a cloth or soft non-metallic brush.
Do not use water or any cleaning
solutions.
Español (traducido de las instrucciones originales)