16
English
Shut-down
1. Place the engine ON/OFF switch (C) to the OFF Position.
2. Place the fuel valve lever (T) in the OFF postion.
NOTE:
If finished using compressor, follow Steps 3–7.
3. Turn regulator knob (F) counterclockwise until fully closed. Ensure
regulated pressure gauge reads 0 PSI.
4. Remove hose and accessory.
5. Drain the air tank. Ensure air tank pressure gauge reads 0 PSI.
CAUTION:
Risk of property damage. Place engine fuel valve lever
(T) in the OFF position before moving or transporting unit.
WARNING:
Risk of bursting. Drain air tank daily. Water will condense
in air tank. If not drained, water will corrode and weaken the air tank
causing a risk of air tank rupture
.
6. Allow the compressor to cool down.
7 . Wipe air compressor clean and store in a safe, non freezing area.
MAINTENANCE
WARNING:
The following procedures must be followed when
maintenance or service is performed on the air compressor.
1. Ensure engine ON/OFF switch (C) is in the OFF position.
2. Disconnect spark plug wire.
3. Drain air tank.
4. Allow air compressor to cool down before starting service
NOTE:
All compressed air systems contain maintenance parts (e.g.
oil, filters, separators) that are periodically replaced. These used parts
may contain substances that are regulated and must be disposed of in
accordance with local, state, and federal laws and regulations.
NOTE:
Take note of the positions and locations of parts during
disassembly to make reassembly easier.
NOTE:
Any service operations not included in this section should
be performed by a D
E
WALT factory service center or a D
E
WALT
authorized service center.
Maintenance Chart
Procedure
Daily
Weekly
Monthly
1 year or
200 Hours
Check safety valve
X
Inspect air filter
+
X
Drain air tank
X
Check pump oil level
X
Change pump oil**
+
X
Oil leak inspection
X
Inspect drive belt
X
Check drive belt tension
X
Check pulley/flywheel
alignment
X
Check for unusual noise/
vibration
X
Check for air leaks*
X
Clean compressor exterior
X
Engine
See engine instruction manual.
* To check for air leaks apply a solution of soapy water around joints. While
compressor is pumping to pressure and after pressure cuts out, look for
air bubbles to form.
** The pump oil must be changed after the first 20 hours or operation.
Thereafter, when using
D
E
WALT
synthetic compressor oil, change oil
every 200 hours of operation or once a year, whichever comes first.
+ Perform more frequent in dusty or humid conditions.
