4
WARNING: ALWAYS wear proper personal hearing protection that conforms to
AS/NZS1270 during use.
Under some conditions and duration of use, noise from this
product may contribute to hearing loss.
WARNING:
We recommend the use of a residual current device with a residual
current rating of 30mA or less.
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V .................... volts
A ...............amperes
Hz .................. hertz
W ..............watts
min ................ minutes
...........alternating current
.............. direct current
...........alternating or direct current
................ Class I Construction
no ..............no load speed
......................
(grounded)
.............earthing terminal
................. Class II Construction
.............safety alert symbol
......................
(double insulated)
BPM ..........beats per minute
…/min ........... per minute
RPM ..........revolutions per minute
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
SAVE THESE INSTRUCTIONS FOR FUTURE USE
FIG. 1
HAMMERDRILLING
MODE
CHIPPING MODE
CHISEL BIT ADJUSTMENT MODE
CHISEL BIT ADJUSTMENT MODE
C
H
B
A
I
F
J
N
K
M
O
P
E
D
E
R
