DeWalt D25580, Manual

Page: 7 / 40

ENGLISH
5
4) POWER TOOL USE AND CARE
Do not force the power tool. Use the
correct power tool for your application.
The correct power tool will do the job
better and safer at the rate for which it was
designed.
Do not use the power tool if the switch
does not turn it on and off.
Any power
tool that cannot be controlled with the
switch is dangerous and must be repaired.
Disconnect the plug from the power
source and/or the battery pack from
the power tool before making any
adjustments, changing accessories, or
storing power tools.
Such preventive
safety measures reduce the risk of starting
the power tool accidentally.
Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any other
condition that may affect the power
tool’s operation. If damaged, have the
power tool repaired before use.
Many
accidents are caused by poorly maintained
power tools.
Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to bind
and are easier to control.
Use the power tool, accessories and
tool bits etc., in accordance with these
instructions taking into account the
working conditions and the work to be
performed.
Use of the power tool for
operations different from those intended
could result in a hazardous situation.
5) SERVICE
Have your power tool serviced by a
qualified repair person using only
identical replacement parts.
This will
ensure that the safety of the power tool is
maintained.
Additional Safety Instructions for
Demolition Hammers
Wear ear protectors. Exposure to noise can
cause hearing loss.
Use auxiliary handles supplied with the
tool.
Loss of control can cause personal
injury.
Hold power tools by insulated gripping
surfaces when performing an operation
where the cutting tool may contact
hidden wiring or its own cord.
Cutting
accessory Contacting a “live” wire may make
exposed metal parts of the tool “live” and
shock the operator.
Be certain that the material being drilled does
not conceal electric or gas service and that
their locations have been verified with the
utility companies.
Keep a firm grip on the tool at all times.
Do not attempt to operate this tool
without holding it with both hands.
Operating this tool with one hand will result in
loss of control. Breaking through or
encountering hard materials such as re-bar
may be hazardous as well. Tighten the side
handle securely before use.
Ensure the chisel is secured in place before
operating the tool.
In cold-weather conditions or when the tool
has not been used for a longer period of time,
let the tool run with no load for several
minutes before use.
When working above ground level ensure the
area below is clear.
Do not touch the chisel or the parts close to
the chisel immediately after operation, as they
may be extremely hot and cause burns to the
skin.
Always direct the power cable to the rear,
away from the chisel.
Do not operate this tool for long periods
of time.
Vibration caused by hammer action
may be harmful to your hands and arms. Use
gloves to provide extra cushion and limit
exposure by taking frequent rest periods.
a)
b)
c)
d)
e)
f)
g)
a)
•
•
•
•
•
•
•
•
•
•
•