Devolo Vianect AIR TV, Quick Manual, Page: 17 / 39

16 Initial use
devolo Vianect AIR TV
Observe the setup instructions listed in
the previous section. (see
3.4 Setup in-
structions )
햴
To connect the Vianect AIR TV station to a TV set
or projector via HDMI , connect both devices via
an HDMI cable ; digital image and sound data
are transmitted via the HDMI cable simultane-
ously .
or
햵 To connect the Vianect AIR TV station to a TV set
or projector via VGA ( image transmission), con-
nect both devices via a VGA cable . For sound
transmission , connect the 3.5 mm jack sock-
ets of the devices (TV set, projector or stereo sys-
tem) via a cable with 3.5 mm jack plug.
If the sound transmission does not work au-
tomatically after complete and correct instal-
lation of the hardware and software, in the
sounds and audio devices properties, under
Audio select as the default device for sound
playback
USB PnP Sound device
. For more
detailed help on verifying the settings, refer
to our online FAQs on our website at
www.devolo.com .
햶
If you want to connect additional TV sets or pro-
jectors, simply repeat steps
��� to ��� for each
device.
3.7 Restoring the pairing
To again configure the devices, proceed as follows:
햲 If you have not done so already, install the pro-
vided devolo software on your computer. (see
Chapter
3.5 Software installation )
햳
Then insert the computer adapter into an availa-
ble USB socket of your computer.
햴 Remove the computer adapter and, in its place,
plug the TV adapter into the now available USB
socket of your computer. After a few seconds, a
message appears stating that the pairing is
completed.