Cable not connected properly
Make sure that the cable is
properly connected to both the
speaker and the amplifier.
Defective cable
Try using another cable to
determine whether the cable is the
problem.
Volume control is not turned up
Turn up the volume control on the
signal source and/or amplifier to a
sufficient level.
Red Clip Limiter LED lights up
often or continually
Volume is too high
Lower the volume of the input
signal or the amplifier. Overloading
the speaker can cause permanent
damage.
Connected device is transferring a
distorted signal
Check if any of the connected
source devices are transferring a
distorted signal and turn down the
volume on the offending device if
necessary.
The information in this user manual is subject to change at any time without notice.
Version:
1.0
Date of creation and author's initials:15-07-2019 RV
Revision date and author's initials: -
