DeVilbiss PRI Pro Lite, Service Manual

Page: 10 / 24

EN
If quick connect couplings are required, use only high flow quick connects. Other types will not flow
enough air for correct gun operation.
KEY
Order for disassembly
To clean air cap and fluid tip, brush exterior with a stiff bristle brush. If necesarry to clean cap holes,
use a broom straw or toothpick if possible. If a wire or hard instrument is used, extreme care must
be taken to prevent scratching or burring of the holes which will cause a distorted spray pattern.
To clean fluid passages, remove excess material, then flush with gun wash solution. Wipe the gun
exterior with a dampened cloth. Never completely immerse in any solvent or cleaning solutions as
this is detrimental to the lubricants and life of the spray gun.
SPRAY GUN DISASSEMBLY / ASSEMBLY
SPRAY GUN MAINTENANCE & CLEANING
- see over page
(reverse for assembly)
- see over page
Item Number
NOTE
NOTE
Depending on hose length, larger I.D. hose may be required. Install an air gauge at the gun handle.
When gun is triggered on, adjust regulated pressure as required. Do not use more pressure than is
necesarry to atomise the material being applied. Excess pressure will create additional overspray and
reduce transfer efficiency.
#
#
SB-E-2-859 R1.1
10/24