2
© 2003 ITW Finishing Systems and Products
E
Operation Manual
FLG5 – Suction-feed Spray Gun
Important
Read and follow all instructions and Safety Precautions before using this
equipment
Description
The FLG5 Suction-feed Spray gun is fitted with a 1.8mm nozzle for topcoat applications. The
FLG5 Spray gun is approved to ATEX regulations 94/9/EC, protection level;
II 2 G X. Suitable for use in Zones 1 and 2
Important: These spray guns are suitable for use with both water-based and solvent-based
coating materials. The design uses EPA compliant atomising (Devilbiss Trans-Tech®)
technology to reduce overspray and improve coating efficiency. Nozzles and needles are
manufactured in stainless steel. These guns are not designed for use with highly corrosive
and/or abrasive materials and if used with such materials it must be expected that the need for
cleaning and/or replacement of parts will be increased. If there is any doubt regarding the
suitability of a specific material contact your local Distributor or ITW Finishing direct.
Specification
Air supply connection -
Universal ¼” BSP and NPS
Maximum static air inlet pressure -
P
1
= 12 bar (175 psi)
Nominal gun inlet pressure with gun triggered -
2.4 bar (35 psi)
Maximum service temperature -
40°C
Gun
weight
-
930
g
Air
flow
-
277
l/min
(9.8
cfm)
Materials of Construction
Gun body
-
Aluminium
Nozzle - Stainless
steel
Needle - Stainless
steel
Cup
-
Aluminium and steel
ITW Finishing Systems and Products reserve the right to modify equipment specification without prior notice.
