1. Unpack the powerchair and place the
powerchair so the front is on the floor.
Make sure to release the stopping pin
holding the anti-tip wheels in place on
the inside of the rear wheels. Extend the
anti-tip wheels and reposition the clip into
the 3rd slot.
2.
Install joystick. Turn the securement
knob to loosen. Insert the joystick tubing.
When the required position is reached,
tighten the knob to secure.
3. Add the cable clips to the frame.
4. Insert battery. Slide the battery on to the rails under-
neath the seat. Push the battery firmly backwards until
it locks in position with an audible click.
5. Switch on folding mechanism. Set the lower switch
at the rear of the chair to ‘I’. To fold out the powerchair,
press the upper switch on the side marked ‘I’. Continue
to press until the powerchair is fully folded out.
6. Install battery in remote fob (CR2032). Open the
battery compartment. Insert the CR2032 battery and
then press together the plastic housing to lock. (Note:
for some markets, the battery may already be installed).
7. Put freewheel levers into ‘Electric’ mode by
pushing the levers forward. Repeat for both
motors.
8. Drop down armrests and pull-down
footrest.
9. Install the seat and back cushions which
attach with Velcro (if required)
10. Charge battery. The battery can be charged via the
powerchair by inserting the charger into the socket on
the underside of the joystick. The battery can also be
charged directly when removed from the powerchair.
(See section 8.3 of the Instructions for use for more
details).
11. Switch the powerchair on using the joystick. Ensure
the charger is removed before operation.
12.Using the remote fob after
initial set up.
To
unfold
the powerchair:
• Press
• Press
• Press and hold until motion has
finished.
To
fold
the powerchair:
• Press
• Press
• Press and hold until motion has
finished.
To unfold powerchair
To fold powerchair
(See section 8.3 of the Instructions for use for more
details).
Follow these instructions to safely set up your new powerchair
NB. images are for illustration and parts identification purposes only, and may not reflect final
product outlook and /or appearance.
