DeView D410-THRE3V12L, Instruction Manual

Page: 3 / 4

SPECIFICATION
MODEL
General Spec NTSC PAL
CCD Type
1/3" 410K Pixels Color 1/3" 470k Pixels Color
Total number of pixels 811(H) X 508 (V) 795(H) X 596(V)
Min illumination
Video Output
Resolution
S/N Ratio
Shutter speed x128 : 1/60~1/120,000sec x128 : 1/50~1/120,000sec
Sync System
White Balance
OSD
Built-in
DAY / NIGHT
AUTO / B/W / COLOR
DNR LOW, MIDDLE, HIGHT,OFF
Power Input
Video Output
Voltage
Power Consumption
Lens
Dimension
Weight
Case Color
Operation temp
-10 Ԩ ׽ +55 Ԩ
900g
Ivory
Max [DC12V : 5.7 W, AC24V : 5.3 W, with Heater DC12V : 18W, AC24V :
12W]
Mechanical Spec
3.3~12.0 mm
140(ø) X 105(H)mm
Wire
BNC Cable
Electric Spec
DC 12V(10 - 20V) or AC24V(20 - 28V)
50dB (AGC off, weight ON)
Internal / External
ATW/AWC/MANUAL (1800 ˚ K ~ 10,500 ˚ K)
Connector
D410-THRN3V12L (+HTR) / D410-THRE3V12L (+HTR)
0.3 Lux/F1.2(50 IRE, AGC HIGH, DNR HIGH)
1.0Vp-p/75 ohm Composite
520 TV Lines(Min)
Models equipped with heater: -40°C ~ +55°C
INSTALLATION
1. Use the supplied L-wrench to remove the four fixing
screws (B) of dome cover (A).
2. Align the camera unit with the surface of the ceiling,
make marks on the ceiling in the places where the screw
holes are to be drilled, and then drill the four holes.
3. Cut a hole (diameter2.9in.73mm) in the ceiling for routing
the cables.
4. Pass the power cable (E) and video cable (F) from the
camera unit through the cable hole in the ceiling.
5. Align the four screw holes in the camera unit (D) with
the screw holes in the ceiling, and then secure the
camera in place by tightening the four or more screws
(C) through the washers. Remember to use the base
gasket.
6. Carry out the settings and adjustments for the camera.
7. Ensure all cable entry points (rear or side) are sealed
with silicone sealent to prevent moisture ingress.
Failure to observe this may result in condensation
deposits that will reduce the IR response of the camera
In storage temp
Operation humidity
-20 Ԩ ׽
+70
Ԩ
Under 90
％
(Non-condensing)
q pp
A
D
C
E F
deposits that will reduce the IR response of the camera.
8. Secure the dome cover (A) by tightening the screws (B).
B