E-5
IV. Paper feed check
1. Plug the power cord into the power outlet and
turn on the machine.
2. Press the Paper key to select the tray2.
3. Press the Start key to check for correct paper
feed.
If the paper is not properly fed, perform the fol-
lowing adjustment.
(1) Remove the rear cover. (11 screws)
(2) Loosen the screw shown in the illustration and
adjust the position of the screw. Retighten the
screw.
Note:
Be sure not to push the bracket hard to the direc-
tion of the arrow. If this step is not carried out in
the proper manner as described above, paper
conveyance failure may result.
(3) Make a paper feed check again and confirm
that paper is fed without problem.
(4) Reinstall the rear cover. (11 screws)
Note:
• When the optional reverse automatic document
feeder (DF-625) is installed, make sure that the
harness cover is not detached, and then attach
the rear cover.
• Be aware that only the screw A is different from
other screws.
V. CD registration adjustment
1. Load the adjustment tray with A4
or Letter
paper.
2. Display the Service Mode screen. (For details of
how to display the service mode screen, see the
service manual.)
3. Press
▼
or
▲
key to select “FUNCTION” on the
display.
4. Press the [OK] key.
5. Press
▼
or
▲
key to select “PRN TEST PAT-
TERN” on the display.
6. Press the [OK] key.
7. Press
▼
or
▲
key to select the adjustment tray on
the display.
8. Press the [OK] key.
9. Press
▼
or
▲
key to select “PATTERN1” on the
display.
10. Press the OK key to start the test print.
A3PFIXC019DA
A3PFIXC020DA
Screw
A3PFIXC021DA
Harness cover
A
