Installation
Supplied kit to install
:
T° sensor, X4 connector, Ø25mm steel
tube and fixing clamps
15
16
17
X4
160
mm
The electrical wiring of the temperature sensor is
made on terminals 15 and 16 of the X4 connector
of the main circuit board
réf :
500101/04
(
s.a. the right hand side drawing
)
Electro
V
ap
C
MC
Optional t
emperature control system
Installation
12
Pho
tos non-contractuelles
For sanitation : this sytem holds the water in the cylinder at a temperature of 65°C (150°F) to prevent
bacteria or mold from forming in the cylinder even if there is no humidity demand.
For fast boiling : When there is a demand for humidity, the water boils more quickly than with cold water.
This produces a faster response to the humidistat and more accurate control.
For freeze protection : Can prevent freeze-up if the humidifer is subject to cold environments. (Additional
protection required for the water feed and drain lines).
The optional temperature control system
overrides
the automatic factory pre-set draining
time where the
cylinder(s) is (are) drained by the
system after x hours of stop
(s.a. page 3)
.
Note : the humidifier must be switched on for this system to operate.
6.30in
