65 Aleksandar Stamboliyski Str., 8000 Bourgas, Bulgaria
Tel: +359 56 820027, Fax: +359 56 836700
E-mail: [email protected] ,Web: www.devabroadcast.com
- 23 -
HARDWARE RESET
This process will fully restore DB90-TX to its Factory Defaults, including the Network settings.
Hardware Reset can be done by following the next steps:
•
Disconnect the power supply cable from the unit.
•
Locate the RESET button on Rear panel.
•
Press and hold the RESET button.
•
Connect the power supply cable to the unit.
•
Keep the RESET button hold until the POWER led starts blinking.
•
Release the RESET button.
•
Wait for DB90-TX to reboot with the factory default settings.
Upon completion of the process DB90-TX settings will have the following values:
Network Default Settings
•
DHCP: enabled
WEB Server Default Settings
•
Port: 80
•
Username: user
•
Password: pass
All other settings will have the factory default values described in chapter “Factory Defaults
NOTE:
After the process completes the DHCP Client is enabled. The DB90-TX will obtain IP
Address from DHCP server shortly.
ATTENTION:
Please note that the WEB Server’s Port, Username and Password will be
changed, so it is possible the page not to be loaded after restoring factory defaults. You may be
asked to re-enter the encoder’s address and/or username and password.