4
ASSEMBLY INSTRUCTIONS
5.
See Figure 2
. Place tank straps “3” in the tank bracket “4” slots and bend tabs up and back against the
bracket. Place the fuel tank in position and attach the straps at their lower end using two 6mm bolts.
6. Connect the fuel line from the engine to the nipple underneath the tank. Use pliers to raise the loose hose
clamp to secure the hose to the tank..
7. Insert the throttle lever through the slot in the center of the control panel then attach the throttle control to the
underside of the control paned using the two screws provided. Ensure both “choke” and “stop” positions are
achieved using the throttle lever. Push the ‘” T “ shaped plastic knob onto the throttle lever.
8. Electric start models. Insert the key-switch through the “D” shaped hole in the rear of the control panel and
secure it with the spring washer and nut provided.
Remove the battery from the battery box and fill it with battery acid (not supplied) to 1-2 mm above the plates.
Clean any spilled acid from the battery then install the battery in the mower. Ensure that the negative terminal is
connected to the frame of the mower (earth). Wait 20 minutes for the battery to charge before attempting to start
the mower. You do not need to connect it to a charger.
ENGINE PREPARATION
(Pre delivery)
1. Remove the dipstick and check the oil level as per the instructions in the engine manual.
2. Add unleaded petrol to the petrol tank.
3. Read and abide by the Safety Instructions listed below then follow the starting procedure listed In the
Operation section. Check there is no abnormal vibration, and that the gear lever, forward drive lever, height
adjustment lever and blade clutch are functioning satisfactorily.
Fig. 2 - Fuel Tank Attachment
