Detecto ProDoc DHRWM, Owner'S Manual

Page: 7 / 12

INSTALLATION
Mounting the Display
The DHRWM display has a 69” (175 cm) cable to allow it to be placed at a convenient position
away from the height rod. A bracket is included to mount the display on a wall or the bracket
(and included feet) can used to place it on a desk for easy viewing.
Wall Mounting
1. Choose the location to mount the display on the wall. The location should be free of
temperature extremes and water. It should be where the display can be easily viewed,
not subject to direct sunlight and where the keypad is within easy reach of the operator.
2. Make certain the structure and mounting hardware are of sufficient strength to support the
display. The mounting bracket should be securely fastened to the wall so that it cannot
break loose from the mounting surface.
3. Referring to Figure No. 2 and using Display Wall Bracket “B” for a template, place the
bracket against the wall ( notch and arrow pointing up ) and mark the holes to use to mount
it. Remove the bracket and drill two (2) 13/64” (5 mm) holes in the wall for the mounting
wall anchors.
4. Insert the wall anchors in the wall until they are flush with the wall.
5. With the notch and arrow pointing up on Display Wall Bracket “B”, insert the two (2)
M3.0x25 screws through the bracket and into the wall anchors.
6. Tighten the screws to secure the bracket to the wall.
M3.0x25 Screw
Display Wall Bracket “B”
Plastic Wall Anchor
13/64” (5 mm)
Hole in Wall
Figure No. 2
0044-M372-O1
y
DHRWM Page 5