8555-0550-0M Rev B
y
MedVue with Wi-Fi and Bluetooth
2
WI-FI SETUP, CONT.
Enable and Configure Wi-Fi Networking, Cont.
8. With
bLE ON/OFF
displayed, press the
ENTER
key.
9. The display will change to show
WIFI ON/OFF
and the current setting.
10. Press the
1
(YES) key to select
on
to enable Wi-Fi and then press the
ENTER
key.
11. The display will change to
dHCP ON/OFF
and show the current setting. Press the
ENTER
key if the current setting is acceptable. Otherwise, press the
0
(NO) or
1
(YES)
key to select a new setting, and then press the
ENTER
key to save it.
Allowable settings are:
off
or
on
.
NOTE:
Select
off
to use a static IP address or select
on
to use a dynamic IP address
assigned by a DHCP server. Consult with your network administrator for the proper
selection.
12. The next prompt will be
IP1
, the first octet of the static IP address.
a.
If
dHCP
was set to
on
, nothing needs to be entered here. Press the
ENTER
key until
the prompt
CLR WIFI CREdS
is displayed.
b.
If
dHCP
was set to
oFF
, using the numeric keys, enter the value for
IP 1
, the first
octet of the static IP address, and then press the
ENTER
key. For example, if the
static IP address is “192.168.0.2”, enter 192 on the numeric keypad, and then press
the
ENTER
key.
c.
The next three prompts will be
IP 2
,
IP 3
, and
IP 4
for the remaining three
octets of the IP address. Using the numeric keys, enter the value for each octet of
the IP address, and then press the
ENTER
key. Repeat this for each octet.
13. The next prompt will be
SUbNET1
, the first octet of the network subnet mask.
a.
If
dHCP
was set to
on
, nothing needs to be entered here. Press the
ENTER
key until
the prompt
CLR WIFI CREdS
is displayed.
b.
If
dHCP
was set to
oFF
, using the numeric keys, enter the value for
SUbNET 1
, the
first octet of the network subnet mask, and then press the
ENTER
key.
c.
The next three prompts will be
SUbNET 2
,
SUbNET 3
, and
SUbNET 4
for the
remaining three octets of the subnet mask. Using the numeric keys, enter the value
for each octet of the network subnet mask, and then press the
ENTER
key. Repeat
this for each octet.
14. The next prompt will be
GATEWAY1
, for the first octet of the network gateway’s IP
address.
a.
If
dHCP
was set to
on
, nothing needs to be entered here. Press the
ENTER
key until
the prompt
CLR WIFI CREdS
is displayed.
b.
If
dHCP
was set to
oFF
, using the numeric keys, enter the value for
GATEWAY 1
,
the first octet of the network gateway’s IP address, and then press the
ENTER
key.
c.
The next three prompts will be
GATEWAY 2
,
GATEWAY 3
, and
GATEWAY 4
for
the remaining three octets of the gateway’s IP address. Using the numeric keys,
enter the value for each octet of the gateway’s IP address, and then press the
ENTER
key. Repeat this for each octet.
